There are a number of tools essential to a pipe fitters toolbox, some more obvious than others but all equally important. PCES stock a huge range of high quality tools for the pipefitter allowing them to properly equip themselves for their next job. Here is a selection of product on offer at PCES right now –
Curb-O-Mark Centering heads
Curv-O-Mark Centring heads aid in the setting of centrelines, establishing angles and marks for butt-ins, location points inside pipes and tanks, laying out keyways and measuring declivity.
Curve-O-Mark Contour Markers
The Cur-O-Mark- Contour marker is a compact, time saving tool used to lay out pipe and structural steel joints.
Curvomark Flange Aligner Base
The Curv-O-Mark Aligner base is notched at either end for ease in aligning on the centreline of the pipe and has two 25 pound pull, cast in magnets for holding either a flat horizontal or vertical position.
Curvomark Wrap-around Pipe Marking Wrap
Curvomark Wrap-A-Round Contour Layout & Marking Tools. Inexpensive tool for marking straight lines around pipe, or for use as a straight edge.
Stainless Steel Flange Alignment Pins – FLUPS
Flange Line Up Pins aid the welder in checking or obtaining critical alignment of flange to the pipe.
Flange Spreaders
A pair of Flange Spreaders are used to gently separate flanges for the replacement of the Flange Gasket or to reapply sealant to the Flange Face.
GAP-A-LET SOCKET WELD RINGS
Gap-A-Let is a split ring that is engineered and designed to give you a pre measured 1/16″ minimum gap for socket welds.
For further information on these PCES Pipefitter tools or other tools they offer visit their website.